See here, for instance for a fuller discussion. All of the above applies to USB3, except that the worst-case cable lengths are 3 meters rather than 5, and any hub or repeater MUST be specified for USB3. Linksys Hydra Pro 6 Mesh WiFi 6 Router - WiFi Extender Replacement - MR5500-AMZ - Mesh WiFi Router for Wireless Internet - WiFi Mesh Wireless Router - Mesh Router Connect to 30+ Devices 2,700 Sq Ft TP-Link WiFi Extender with Ethernet Port, 1.2Gbps signal booster, Dual Band 5GHz/2. USB3 is only suggested for cables of about 10 feet long, or so. ![]() Try connecting the hub to a 10 foot cable, then use another 10 foot cable to the camera. That yours doesn't suggests that you are doing something wrong, such as using a cable assembly more than 5 meters long connected to a hub, and the total is only marginal in terms of functioning. Ad-hoc power management Set power-saving features for device to device (ad-hoc) networks. You can get these in 10 foot lengths easily enough, and use a 10 foot repeater cable followed by, for instance, a 10 foot standard cable to connect to the camera.Ī hub ought to work. Here are 4 unique features available for intel WiFi Chipset you should maximize to amplify the signal received from the router. What you can do is to use a repeater cable, which has a repeater at the end. LinkNYC kiosk awaiting activation at 101st and Amsterdam. 96 Devices with Dual-Band Gigabit Signal Extension Repeater (5GHz / 2.4GHz) 193. So adding extension cables to get a cable more than 5 meters long will not work. Reyee WiFi Extender Booster Signal Repeater,1200 Mbps,2 FEM Independent Signal Amplifier Coverage Up to 7800 sq.ft. The maximum length is fixed by the standard at 16 feet (5 meters). USB is limited in the length of wire it can drive. So I think ideally it should solve my issue, but I cannot understand why it isnt So I do not know if the Hub is amplifying the signals for a 3 meter range (as a USB 3.0 application would require) or for a 5 meter range ( as for a USB 2.0 application ). I have tried using USB 2.0 cable in the USB 3.0 hub.I have connected and used wires of non-uniform thickness throughout the length.I also tried to use a USB 3.0 HUB, assuming that I would get faster speed, but my computer is not able to detect it with the USB 3.0 Hub connected.ĮDIT: I think I need to mention the following information based on answers and comments:. ![]() The computer can detect it, but it is too slow for real time use of the camera. I have tried using a wire extender, But the computer is not able to detect my device(a USB camera). I have a long range wired application (over 5 meters).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |